162+ Rubbermaid Shed Door Handle Replacement Parts

partsfe.com

Opening: Revamping Your Rubbermaid Shed Door Handle on a Budget Is your Rubbermaid shed door handle broken or missing? Don't rush to replace the entire shed! You can easily create a functional DIY replacement handle for a fraction of the cost. This guide will walk you through a simple and effective method for building a handle using readily available materials. Let's get started!

Materials You'll Need

A sturdy piece of wood (approximately 6-8 inches long, 1-2 inches wide, and 1 inch thick scrap wood works great!)

Two large washers (diameter suitable for the screws/bolts you'll be using)

Two screws or bolts with nuts (length should be sufficient to go through the wood, washers, and shed door)

Drill with drill bits (sized appropriately for your screws/bolts)

Sandpaper (medium grit)

Optional: Paint or wood sealant

Step-by-Step Instructions

Step 1: Prepare the Wood: First, sand the piece of wood to remove any splinters or rough edges. This will make the handle more comfortable to grip. Shape the wood as you like, rounding corners is ideal.

Step 2: Drill Pilot Holes: Decide where you want to attach the handle to the shed door. Place the washers on top of your wood handle and mark where the screw/bolt holes will go. Drill pilot holes through the wood at these marked locations. This prevents the wood from splitting when you insert the screws/bolts.

Step 3: Attach the Handle: Position the wood handle on the outside of the shed door. Place a washer on each screw/bolt. Insert the screws/bolts through the shed door, through the washers, and then through the pilot holes in the wood handle. Secure the screws/bolts with nuts on the inside of the shed door. Tighten firmly, but avoid over-tightening, which could crack the wood or the shed door.

Step 4: Finishing Touches (Optional): If desired, paint or seal the wood handle to protect it from the elements and improve its appearance. Allow the paint or sealant to dry completely before using the handle.

Alternative Materials & Considerations While wood is a common choice, you could also use a piece of sturdy plastic or even metal piping (suitably capped for safety) as the base for your handle. Ensure your chosen material can withstand regular use and outdoor conditions. When selecting screws/bolts, consider stainless steel to prevent rusting. Measure the thickness of your shed door carefully to ensure your screws/bolts are the correct length.

Conclusion: A Simple Solution for a Common Problem By following these steps, you've successfully created a functional and cost-effective replacement handle for your Rubbermaid shed. This DIY project not only saves you money but also allows you to customize the handle to your liking. Enjoy your newly functional shed door!